|
As picture below shows when installing the trigger back into
your airbrush (Iwata) hold the trigger (main lever) so that the two posts at
the bottom of the trigger (main lever) face the front and back of the airbrush.
Insert the trigger (main lever) down into the long opening in the top of your
airbrush. Now turn the trigger (main lever) 90 degrees so the posts at the
bottom of the trigger (main lever) are now facing the sides of the airbrush.
Lower the trigger inserting the posts into the slot inside your airbrush. With
this done now tilt the front of the airbrush slightly down ward install the
auxiliary lever so that the arch in that lever faces the back of the airbrush
see picture #2. To insert the auxiliary lever you must also turn this side ways
to get it down into the airbrush than turn it 90 degree's so it ends up as
pictured in #2. |
